OpenBSD crypt() does not support (insecure) crypt-des or crypt-md5
(The password used in the tests and lighttpd.htpasswd is crypt-des.
Something else could be used so that the tests can execute,
though that something might be different on different platforms.)
allow LIGHTTPD_EXE_PATH override to be able to run source tree tests/*.t
against installed executable, e.g. LIGHTTPD_EXE_PATH=/usr/sbin/lighttpd
Beware that tests might not pass or might not be supported if the target
executable is not the same version as that of the source tree
(Possible use for this override is by Debian autopkgtests)
(bug on master branch; never released)
fix crash on master if blank line precedes HTTP/1.1 keep-alive request
header parsing code previously made assumptions that request was
HTTP/1.0 or HTTP/1.1, where a request-line was required, and which
would error out elsewhere if request-line was missing. The parsing
code also previously looked for "\r\n\r\n" to end headers.
The header offset parsing code was modified and invalidated the above
assumptions, now looking only for blank line "\r\n", but the calling
code had not properly been updated. (until this patch)
Location response header is permitted to use relative-path in
RFC 7231 Section 7.1.2. Location
Prefer relative path in redirection for the benefit of reverse proxies
and CDNs. Doing so also avoids potentially disclosing internal schemes
and server names which client might not be able to directly reach.
To restore prior behavior of sending a fully-qualified absolute URI:
server.feature-flags += ("absolute-dir-redirect" => "enable")
translate config server.modules "mod_compress" to "mod_deflate"
accept compress.* directives, but issue DEPRECATED warning trace
mod_deflate differences from mod_compress:
- mod_compress compress.filetype was exact match; deflate.mimetypes is
prefix match (behavior change might compress longer mimetype matches,
which are likely of similar type and compressability)
- mod_compress always sent entire (compressed) file for Range request
mod_deflate will stream compress range result (not stored in cache)
- mod_compress would short-circuit request with 403 Forbidden error
if request file did not exist (stat() failed) (This behavior was
unfriendly to other handlers)
- mod_compress compress.cache-dir layout differs from deflate.cache-dir
layout; file cache should be cleared (or renamed) when migrating from
mod_compress to mod_deflate
- mod_deflate does not issue Vary: Accept-Encoding if request does not
contain Accept-Encoding. The identity response can be cache by
proxies and served to clients. Historically, some proxies disabled
caching if any Vary: response was seen. If the Vary header is
desirable, mod_deflate code which checks for Accept-Encoding and
compression type can be moved down a few lines to be below the
setting of the Vary response header.
reject whitespace following request header field-name and before colon
Such whitespace is forbidden in RFC 7230 Section 3.2.4.
strict header parsing is enabled by default in lighttpd. However,
if explicitly disabled in lighttpd.conf, lighttpd will continue to
accept (and re-format) such field-names before passing to any backend.
UNSAFE: server.http-parseopts = ( "header-strict" => "disable" )
This is NOT RECOMMENDED since doing so disables other protections
provided by lighttpd strict http header parsing.
stricter request header parsing